SimplyCam V3. Documentation

• SimplyCam V3
  • Introduction
• Interface
  • Zoom and Pan
  • Status Bar
  • Snap
  • Layer
• Toolbars
  • File toolbar
  • Create toolbar
  • Edit toolbar
  • View toolbar
  • Status Bar
• Vectorization
  • Vectorize
• Settings
  • Settings
• Toolpath Manager
  • Simulation
  • PostProcessor
• Mill Toolpaths
  • Contour
    • Tools
    • Profiles
    • Parameters
      • Lead In/Out
      • Tabs
  • Pocket
    • Tools
    • Profiles
    • Parameters
      • Lead In/Out
  • Drill
    • Tools
    • Points Select
    • Parameters
  • Parallel
    • Tools
    • Size/Limits
    • Parameters
• Laser, Plasma, Waterjet Toolpaths
  • Cut
    • Tools
    • Profiles
    • Parameters
      • Lead In/Out
      • Tab
  • Laser Engraving
    • Tools
    • Parameters
• Lathe Toolpaths
  • Lathe Rough
    • Tools
    • Profiles
    • Parameters
  • Lathe Finish
    • Tools
    • Profiles
    • Parameters
• Mill tutorials
• Laser, Plasma, WaterJet tutorials
• Lathe tutorials

Lathe Finish Toolpath

The Finish toolpath, removes material along a selected profile. On the profile can be applied the tool tip radius compensation.

Dialogs of Lathe Finish Toolpath

Dialog 1 - Tool Definition
This dialog sets the technological parameters of the tool. These parameters directly affect the G-code generated by the postprocessor.
More information....

Dialog 2 - Defining Profiles
Use this dialog to define and edit the profiles for the selected operation.
This dialogue is also used to define the tool compensation.
More information....

Dialog 3 - Contour Parameters
This dialog contains the parameters specific for the Lathe Finish toolpath.
More information....

Examples of Lathe Finish toolpath

Copyright ©2015 MR-Soft  -   SimplyCam version 3.0.6  -   Help file built on 12/08/2015